Journal of Applied Science and Engineering

Published by Tamkang University Press

1.30

Impact Factor

2.10

CiteScore

K.L. Kumaraswamy1 and T. Krishna Rao This email address is being protected from spambots. You need JavaScript enabled to view it.1

1Department of Mechanical Engineering, Global Academy of Technology, Bengaluru, Karnataka, India


 

Received: September 7, 2021
Accepted: January 26, 2022
Publication Date: August 16, 2022

 Copyright The Author(s). This is an open access article distributed under the terms of the Creative Commons Attribution License (CC BY 4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are cited.


Download Citation: ||https://doi.org/10.6180/jase.202305_26(5).0007  


ABSTRACT


The present research work proposes the design, mathematical formulation, simulation, experimental results and validation of a novel Target Flow Measurement Sensor (TFMS). TFMS is designed and developed based on the magnetic flux experienced by the magnetic sensor, which will be employed for the evaluation of the flow rate of the water for a range of 0lt/s to 4lt/s. A novel transduction methodology is employed in the present study to transduce the water flow rate in a pipe into a translational motion of a magnet towards a magnetic sensor, which results in the form of an increase in the magnetic flux of the sensor output. Mathematical formulations are derived to simulate the response of the TFMS for varying flow rates. The simulated response of TFMS is found to be in good agreement with the experimental results obtained. Further, experimentally the evaluated flow rate response of the TFMS is compared with the flow rates evaluated from a commercial flow meter when both are mounted in-line pipe. Furthermore, the response of the TFMS is studied with varying target plate areas via experimental trials as well as simulations. Collectively, the excellent agreement between the simulation results, TFMS experimental results and commercial flowmeter measurements prove the efficacy of the developed TFMS to measure the water flow rate. Further, the design of the TFMS has the capability of tuneable sensitivity to measure flow rates of varying ranges, which has been proved with the results obtained from varying target plate area trials.


Keywords: Target flow meter; Flow sensor; Flow rate measurement; tuneable sensitivity


REFERENCES


  1. [1] J. Smith, (1995) “Flowmeter review" Sensor Review 15(4): 11–14. DOI: 10.1108/02602289510102318.
  2. [2] R. C. Baker, (1977) “Electromagnetic flowmeters for fast reactors" Progress in Nuclear Energy 1(1): 41–61. DOI: https://doi.org/10.1016/0149-1970(77)90005-1.
  3. [3] A. Kolin, (1945) “An Alternating Field Induction Flow Meter of High Sensitivity" Review of Scientific Instruments 16(5): 109–116. DOI: 10.1063/1.1770341.
  4. [4] P. D. Stein, (1972) “Velocity and flow measurements by electromagnetic techniques" The American Journal of Cardiology 29(3): 401–407. DOI: https://doi.org/10.1016/0002-9149(72)90538-3.
  5. [5] J.-E. Cha, Y.-C. Ahn, and M.-H. Kim, (2002) “Flow measurement with an electromagnetic flowmeter in twophase bubbly and slug flow regimes" Flow Measurement and Instrumentation 12(5): 329–339. DOI: https: //doi.org/10.1016/S0955-5986(02)00007-9.
  6. [6] M. T. Pigott and R. C. Strum, (1967) “Observed Behavior of a Thermistor Bead Flow Meter" Review of Scientific Instruments 38(6): 743–744. DOI: 10.1063/1.1720881.
  7. [7] A. Catellani, R. Stacchietti, A. Taroni, and C. Canali, (1982) “Performance and temperature stability of an air mass flowmeter based on a self-heated thermistor" Sensors and Actuators 3: 23–30. DOI: https://doi.org/10.1016/0250-6874(82)80003-6.
  8. [8] A. H. Fanney and B. P. Dougherty, (1987) “Measurement of Buoyancy-Induced Flow Using a Self-Heated Thermistor Flowmeter" Journal of Solar Energy Engineering 109(1): 34–39. DOI: 10.1115/1.3268175. eprint: https ://asmedigitalcollection.asme.org/solarenergyengineering/article - pdf/109/1/34/5725474/34\_1.pdf.
  9. [9] B. Morten, M. Prudenziati, A. Taroni, and G. Zanarini, (1976) “Experimental results on dynamic behavior of thermistor flowmeters" IEEE Transactions on Instrumentation and Measurement IM-25(3): 232–234. DOI: 10.1109/TIM.1976.6312352.
  10. [10] H. Shaban and S. Tavoularis, (2014) “The wire-mesh sensor as a two-phase flow meter" Measurement Science and Technology 26(1): 015306. DOI: 10.1088/0957-0233/26/1/015306.
  11. [11] R. Thorn, G. A. Johansen, and E. A. Hammer, (1997) “Recent developments in three-phase flow measurement" Measurement Science and Technology 8(7): 691–701. DOI: 10.1088/0957-0233/8/7/001.
  12. [12] A. d. N.Wrasse, D. Bertoldi, R. E. M. Morales, and M. Jose da Silva. “Two-phase flow rate measurement using a capacitive sensor and a Venturi meter”. In: 2017 IEEE SENSORS. 2017, 1–3. DOI: 10.1109/ICSENS.2017.8234150.
  13. [13] J. Han and F. Dong. “Mass flow rate measurement of Gas/liquid two-phase flow in horizontal pipe based on V-cone flow meter and adaptive wavelet network”. In: 2009 IEEE Instrumentation and Measurement Technology Conference. 2009, 1391–1396. DOI: 10.1109/IMTC.2009.5168673.
  14. [14] W. S. Hao and R. Garcia. “Self-Power Digital Pipe Flow Metering”. In: 2014 International Symposium on Computer, Consumer and Control. 2014, 47–50. DOI: 10.1109/IS3C.2014.25.
  15. [15] X. Nan, M. Yan, T. Jinghua, H. Liru, and C.Weimin. “Development on Intelligent Small-Flow Target Flow Meter”. In: 2009 International Forum on Computer Science-Technology and Applications. 3. 2009, 315–317. DOI: 10.1109/IFCSTA.2009.317.
  16. [16] M. Henry, D. Clarke, N. Archer, J. Bowles, M. Leahy, R. Liu, J. Vignos, and F. Zhou, (2000) “A self-validating digital Coriolis mass-flow meter: an overview" Control Engineering Practice 8(5): 487–506. DOI: https://doi.org/10.1016/S0967-0661(99)00177-X.
  17. [17] T. Wang and R. Baker, (2014) “Coriolis flowmeters: a review of developments over the past 20 years, and an assessment of the state of the art and likely future directions" Flow Measurement and Instrumentation 40: 99–123. DOI: https://doi.org/10.1016/j.flowmeasinst.2014.08.015.
  18. [18] T. Boyle, D. Giurco, P. Mukheibir, A. Liu, C. Moy, S. White, and R. Stewart, (2013) “Intelligent Metering for Urban Water: A Review" Water 5(3): 1052–1081. DOI:10.3390/w5031052.
  19. [19] A. Cominola, M. Giuliani, D. Piga, A. Castelletti, and A. Rizzoli, (2015) “Benefits and challenges of using smart meters for advancing residential water demand modeling and management: A review" Environmental Modelling & Software 72: 198–214. DOI: https://doi.org/10.1016/j.envsoft.2015.07.012.
  20. [20] E. A. Ponce, S. B. Leeb, and P. A. Lindahl, (2021) “Know the Flow: Non-Contact Magnetic Flow Rate Sensing forWater Meters" IEEE Sensors Journal 21(1): 802–811. DOI: 10.1109/JSEN.2020.3014843.
  21. [21] Shiqian Cai and H. Toral. “Flow rate measurement in air-water horizontal pipeline by neural networks”. In: Proceedings of 1993 International Conference on Neural Networks (IJCNN-93-Nagoya, Japan). 2. 1993, 2013–2016 vol.2. DOI: 10.1109/IJCNN.1993.717053.
  22. [22] Y. Lee, S. Eun, and S. Oh. “Wireless Digital Water Meter with Low Power Consumption for Automatic Meter Reading”. In: 2008 International Conference on Convergence and Hybrid Information Technology. 2008, 639–645. DOI: 10.1109/ICHIT.2008.172.
  23. [23] T. M. Han and O. M. Myaing. “Design and Construction of Microcontroller-Based Water Flow Control System”. In.
  24. [24] K. S. Shingote and P. Shahane. “Microcontroller Based Flow Control System for Canal Gates in Irrigation Canal Automation”. In: 2016 IEEE 6th International Conference on Advanced Computing (IACC). 2016, 796–800. DOI: 10.1109/IACC.2016.152.
  25. [25] R. Sood, M. Kaur, and H. Lenka, (2013) “DESIGN AND DEVELOPMENT OF AUTOMATIC WATER FLOW METER" International Journal of Computer Science, Engineering and Applications 3: 49–59.
  26. [26] S. M. Enamorado, M. D. Hurtado, L. Andreu, F. Martínez, J. Sánchez, A. Delgado, and J.-M. Abril, (2007) “Development of a recording water flow meter using ultrasonic measurement of water levels in a slotted U-pipe" Agricultural Water Management 88(1): 263–268. DOI: https://doi.org/10.1016/j.agwat.2006.10.003.
  27. [27] X. Nan, M. Yan, T. Jinghua, H. Liru, and C.Weimin. “Development on Intelligent Small-Flow Target Flow Meter”. In: 2009 International Forum on Computer Science-Technology and Applications. 3. 2009, 315–317. DOI: 10.1109/IFCSTA.2009.317.
  28. [28] N. Munasinghe and G. Paul, (2020) “Ultrasonic-Based Sensor Fusion Approach to Measure Flow Rate in Partially Filled Pipes" IEEE Sensors Journal 20(11): 6083–6090. DOI: 10.1109/JSEN.2020.2972376.
  29. [29] A. K. Lall, A. Khandelwal, R. Bose, N. Bawankar, N. Nilesh, A. Dwivedi, and S. Chaudhari. “Making AnalogWater Meter Smart using ML and IoT-based Low-Cost Retrofitting”. In: 2021 8th International Conference on Future Internet of Things and Cloud (FiCloud). 2021, 157–162. DOI: 10.1109/FiCloud49777.2021.00030.
  30. [30] Bekriev, Ognyan and Stanilov, Aleksandar, (2021) “Experimental study of the accuracy of measuring of a central water meter" E3SWeb Conf. 327: 04004. DOI:10.1051/e3sconf/202132704004.


    



 

2.1
2023CiteScore
 
 
69th percentile
Powered by  Scopus

SCImago Journal & Country Rank

Enter your name and email below to receive latest published articles in Journal of Applied Science and Engineering.