K. I. Hwu This email address is being protected from spambots. You need JavaScript enabled to view it.¹

¹Institute of Electrical Engineering, National Taipei University of Technology, Taipei, Taiwan 106, R.O.C.

REFERENCES

1. [1] B. K. Bose, “Microcomputer Control of Power Electronics and Drives,” In IEEE Press, pp. 640, 1996.
2. [2]    L. Brush, “Trends in digital power management: power converter and system demand characteristics,” Proc. 10th Annu. Conf. Applied Power Electronics, pp. 161-166, 2005.
3. [3]  D. He and R. M. Nelms, “Current-mode control of a DC-DC converter using a microcontroller: implementation issues,” Proc. 11th Annu. International Conf. Power Electronics and Motion Control, pp. 538-543, 2004.
4. [4]   D. He, W. Dilliard and R. M. Nelms, “Microcontroller implementation of current-mode control for a discontinuous mode boost converter,” Proc. 2th Annu. International Conf. Energy Conversion Engineering, pp. 255-260, 2004.
5. [5]  D. He and R. M. Nelms, “Peak current-mode control for a boost converter using an 8-bit microcontroller,” Proc. 34th Annu. Conf. Power Electronics Specialist, pp. 938-943, 2003.
6. [6]    P. T. Tang and C. K. Tse, “Design of DSP-based controller for switching power converters,” Proc. 10th Annu. International Conf. Computers, Communications, Control and Power Engineering, pp. 889-894, 1996.
7. [7]    A. Prodic, D. Maksimovic and R. W. Erickson, “Design and implementation of a digital PWM controller for a high-frequency switching DC-DC power converter,” Proc. 27th Annu. Conf. Industrial Electronics Society, pp. 893-898, 2001.
8. [8]    C. H. Chan and M. H. Pong, “DSP controlled power converter,” Proc. 1th Bienni. International Conf. Power Electronics and Drive Systems, pp. 364-369, 1995.
9. [9]    Guo Liping, J. Y. Hung and R. M. Nelms, “PID controller modifications to improve steady-state performance of digital controllers for buck and boost converters,” Proc. 7th Annu. Conf. Applied Power Electronics, pp. 381-388, 2002.
10. [10]  S. Chattopadhyay and S. Das, “A digital current mode control technique for DC-DC converters,” Proc. 10th Annu. Conf. Applied Power Electronics, pp. 885-891, 2005.
11. [11] Z. H. Jiang, X. D. Sun and L. P. Huang, “The controller of high frequency and high dynamic performance dual-boost PFC module based on DSP,” Proc. 29th Annu. Conf. Industrical Electronics society, pp. 249-254, 2003.
12. [12] L. Guo, J. Y. Hung and R. M. Nelms, “Digital controller design for buck and boost converters using root locus techniques,” Proc. 29th Annu. Conf. Industrical Electronics society, pp. 1864-1869, 2003.
13. [13]  M. M. Islam, D. R. Allee, S. Konasani and A. A. Rodriguez, “A low-cost digital controller for a switching DC converter with  improved voltage regulation,” IEEE Power Electronics Letters, pp. 121-124, 2004.
14. [14]  S. Saggini, G. Garcea, M. Ghioni and P. Mattavelli, “Analysis of high-performance synchronous-asynchronous digital control for dc-dc boost converters,” Proc. 10th Annu. Conf. Applied Power Electronics, pp. 892-898, 2005.
15. [15]  K. Wang, N. Rahman, Z. Lukic and A. Prodic, “All-digital DPWM/DPFM controller for low-power DC-DC converters,” Proc. 11th Annu. Conf. Applied Power Electronics, pp. 719-723, 2006.
16. [16]  Y. T. Yau, K. I. Hwu, Yung-Shan Chou, “Forward converters using a CPLD-based control technique to obtain a fast transient load response,” Proc. 5th Bienni, International Conf. Power Electronics and Drive Systems, pp. 359-364, 2003.
17. [17] N. Mohan, T. M. Undeland and W. P. Robbins, Power Electronics: Converters, Application and Design (2nd, Wiley, 1995).