Journal of Applied Science and Engineering

Published by Tamkang University Press

1.30

Impact Factor

2.10

CiteScore

Ragupathi This email address is being protected from spambots. You need JavaScript enabled to view it.1, Debabrata Barik2, G. Vignesh3, S. Aravind3

1Research Scholar, Department of Mechanical Engineering, Karpagam Academy of Higher Education, Coimbatore, India, 641021.
2Associate Professor, Department of Mechanical Engineering, Karpagam Academy of Higher Education, Coimbatore, India, 641021.
3Assistant Professor, Department of Mechanical Engineering, Karpagam Academy of Higher Education, Coimbatore, India, 641021.


 

Received: May 13, 2019
Accepted: September 4, 2019
Download Citation: ||https://doi.org/10.6180/jase.202003_23(1).0007  

ABSTRACT


The present research work is focused on electricity generation from the heat energy which is wasted through the burnt exhaust gas (BEG) of an internal combustion (IC) engine.  A horizontal tube straight pass duct (HTSPD) type heat exchanger (HE) with a thermoelectric generator (TEG) was used for energy recovery. The HTSPD type HE was designed, fabricated and experimentally investigated the capacity for power generation in connection with TEG. In HTSPD type HE, water was used as the working fluid to transfer heat from the burnt exhaust gas to the TEG modules. A 6-kW diesel engine was used for the experimental analysis and the load on the engine was varied from 25% to 100% in steps of 25%. It was observed that a maximum of 0.27 kW of electricity was produced when the fluid temperature in the heat exchanger (HE) was maintained at 138°C, and the engine was operated at 100% load condition. The electricity produced by TEG modules enhances the overall efficiency, and this method also considerably reduced the thermal pollution due to high-temperature exhaust emissions.


Keywords: Duct type heat exchanger; Electricity generation; IC engines; Thermoelectric generator; Waste heat.



REFERENCES


  1. [1]     Tang Z. B., Y. D. Deng, C. Q. Su, W. W. Shuai, and C. J. Xie. "A research on thermoelectric generator's electrical performance under temperature mismatch conditions for automotive waste heat recovery system." Case Studies in Thermal Engineering 5 (2015): 143-150. DOI:       10.1016/j.csite.2015.03.006
  2. [2]     Albadr, Jaafar, Satinder Tayal, and MushtaqAlasadi. "Heat transfer through heat exchanger using Al2O3nanofluid at different concentrations." Case Studies in Thermal Engineering 1, no. 1 (2013): 38-44. DOI:      10.1016/j.csite.2013.08.004
  3. [3]     Khaled, Mahmoud, Mohamad Ramadan, Khaled Chahine, and Ali Assi. "Prototype implementation and experimental analysis of water heating using recovered waste heat of chimneys." Case Studies in Thermal Engineering 5 (2015): 127-133. DOI:  10.1016/j.csite.2015.03.004
  4. [4]     Orr, B., A. Akbarzadeh, M. Mochizuki, and R. Singh. "A review of car waste heat recovery systems utilising thermoelectric generators and heat pipes." Applied Thermal Engineering 101 (2016): 490-495.
  5. [5]     Remeli, Muhammad Fairuz, L. Kiatbodin, B. Singh, K. Verojporn, A. Date, and A. Akbarzadeh. "Power generation from waste heat using heat pipe and thermoelectric generator." Energy Procedia 75 (2015): 645-650. DOI:   10.1016/j.egypro.2015.07.477
  6. [6]     Lan, Song, Zhijia Yang, Rui Chen, and Richard Stobart. "A dynamic model for thermoelectric generator applied to vehicle waste heat recovery." Applied energy 210 (2018): 327-338.    DOI:10.1016/j.apenergy.2017.11.004
  7. [7]     Aghaali H, Angstrom H-E. A review of turbocompounding as a waste heat recovery system for internal combustion engines. Renew Sustain Energy Rev (2015); 49:813-824. DOI:  10.1016/j.rser.2015.04.144
  8. [8]     Yu S, Du Q, Diao H, Shu G, Jiao K. Start-up modes of thermoelectric generator based on vehicle exhaust waste heat recovery. Appl Energy (2015); 138:276-290. DOI: 10.1016/j.apenergy.2014.10.062
  9. [9]     He W, Wang S, Yue L. High net power output analysis with changes in exhaust temperature in a thermoelectric generator system. Appl Energy (2017); 196:259–267. DOI:   10.1016/j.apenergy.2016.12.078
  10. [10]   Aranguren P, Astrain D, Rodríguez A, Martínez A. Experimental investigation of the applicability of a thermoelectric generator to recover waste heat from a combustion chamber. Appl Energy (2015);152:121–30. DOI: 10.1016/j.apenergy.2015.04.077
  11. [11]   Hsu C-T, Huang G-Y, Chu H-S, Yu B, Yao D-J.An effective Seebeck coefficient obtained by experimental results of a thermoelectric generator module.Appl Energy 2011;88(12):5173–5179. DOI:   10.1016/j.apenergy.2011.07.033
  12. [12]   Pandiyarajan, V., M. Chinna Pandian, E. Malan, R. Velraj, and R. V. Seeniraj. "Experimental investigation on heat recovery from diesel engine exhaust using finned shell and tube heat exchanger and thermal storage system." Applied Energy 88, no. 1 (2011): 77-87. DOI:          10.1016/j.apenergy.2010.07.023
  13. [13]   Remeli, Muhammad Fairuz, K. Verojporn, B. Singh, L. Kiatbodin, A. Date, and A. Akbarzadeh. "Passive heat recovery system using combination of heat pipe and thermoelectric generator." Energy Procedia 75 (2015): 608-614. DOI:  10.1016/j.egypro.2015.07.465
  14. [14]   Ding, Lai Chet, Nathan Meyerheinrich, Lippong Tan, KawtarRahaoui, Ravi Jain, and AliakbarAkbarzadeh. "Thermoelectric power generation from waste heat of natural gas water heater." Energy Procedia 110 (2017): 32-37. DOI:      10.1016/j.egypro.2017.03.101
  15. [15]   Maheswari, K. S., K. KalidasaMurugavel, and G. Esakkimuthu. "Thermal desalination using diesel engine exhaust waste heat—an experimental analysis." Desalination 358 (2015): 94-100. DOI:   10.1016/j.desal.2014.12.023
  16. [16]   Rana, Sohel, Bradley Orr, Arbab Iqbal, Lai Chet Ding, AliakbarAkbarzadeh, and Abhijit Date. "Modelling and optimization of low-temperature waste heat thermoelectric generator system." Energy Procedia 110 (2017): 196-201.
  17. [17]   LeBlanc, Saniya. "Thermoelectric generators: Linking material properties and systems engineering for waste heat recovery applications." Sustainable Materials and Technologies 1 (2014): 26-35. DOI:   10.1016/j.egypro.2017.03.127
  18. [18]   Bradley Orr, and AliakbarAkbarzadeh. "Prospects of waste heat recovery and power generation using thermoelectric generators." Energy Procedia 110 (2017): 250-255. DOI:   10.1016/j.egypro.2017.03.135
  19. [19]   D. Dai, Y. Zhou, J. Liu, Liquid metal based thermoelectric generation system for waste heat recovery. Renew. Energy 36 (2011) 3530–3536. DOI:10.1016/j.renene.2011.06.012
  20. [20]   Q.E. Hussain, D.R. Brigham, C.W. Maranville, Thermoelectric exhaust heat recovery for hybrid vehicles, SAE Int. J. Engines 2 (2009) 1132–1142. DOI:            10.4271/2009-01-1327
  21. [21]   N. Espinosa, M. Lazard, L. Aixala, H. Scherrer, Modeling a thermoelectric generator applied to diesel automotive heat recovery, J. Electron. Mater. 39 (2010) 1446–1455. DOI:    10.1007/s11664-010-1305-2
  22. [22]   M. Mori, T. Yamagami, M. Sorazawa, T. Miyabe, S. Takahashi, T. Haraguchi, Simulation of fuel economy effectiveness of exhaust heat recovery system using thermoelectric generator in a series hybrid, SAE Int. J. Mater. Manuf. 4 (2011) 1268–1276.
  23. [23]   C.T. Hsu, G.Y. Huang, H.S. Chu, B. Yu, D.J. Yao, Experiments and simulations onlow-temperature waste heat harvesting system by thermoelectric power generators, Appl. Energy 88 (2011) 1291–1297. DOI:   10.1016/j.apenergy.2010.10.005


    



 

2.1
2023CiteScore
 
 
69th percentile
Powered by  Scopus

SCImago Journal & Country Rank

Enter your name and email below to receive latest published articles in Journal of Applied Science and Engineering.